Hi Team.
I am working with and ECIOP16 with no bootloader on it as I am using PK3 to program it from MPLAB and now I am doing a project with it in FC8
however when compile to chip everything works fine except that the Programming window reports the chip is not empty and FC abort the programming.Using MPLAB IPE no problem I program device what can cause this issue any help will be appreciated I would like to program directly from FC as with all other chips and devices
PK3 Errors with dsPIC in V8
Moderator: Benj
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
PK3 Errors with dsPIC in V8
- Attachments
-
- P1.jpg (53.21 KiB) Viewed 2103 times
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
-
- Valued Contributor
- Posts: 654
- Joined: Fri Aug 19, 2016 2:09 pm
- Location: switzerland
- Has thanked: 182 times
- Been thanked: 179 times
- Contact:
Re: PK3 Errors with dsPIC in V8
Hi QMESAR
I have some problem with the ICD4 and PIC32 too.
The good thing is, I can Programm the PIC even there is an error.
The bad thing is I can not read the Pic with the Mplab IPE 5.2 anymore.
If I get a new board what I did not Programm with FC8 I can read the Pic with Mplab IPE 5.2
You can try to delet your PIC with the Mplab IPE 5.2 an program it with FC8.
Stefan
I have some problem with the ICD4 and PIC32 too.
The good thing is, I can Programm the PIC even there is an error.
The bad thing is I can not read the Pic with the Mplab IPE 5.2 anymore.
If I get a new board what I did not Programm with FC8 I can read the Pic with Mplab IPE 5.2
You can try to delet your PIC with the Mplab IPE 5.2 an program it with FC8.
Stefan
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: PK3 Errors with dsPIC in V8
Thanks Stefan I will try
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: PK3 Errors with dsPIC in V8
HI Stephan.
Erasing the chip and then try to program with FC does not work on this chip,any case thank again for your help,
I will just keep going with MPE for now
Erasing the chip and then try to program with FC does not work on this chip,any case thank again for your help,
I will just keep going with MPE for now
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR