PIC32 UART port Remap Pins setup
Posted: Thu Aug 01, 2019 6:30 pm
Hi Ben,
I have a problem with the PIC32MZ2048EFM100 MCU, UART component Remap Pin settings.
Bug Description:
First I create a new project and only add one UART (RS232) component to the 2D dashboard.
Then I try to configure TX and RX Remap Pins, but the "Properties" window shows the wrong ports for the selection.
If I choose an other channel and try to set again a TX and RX ports, then first, a different port name will be added to the table than the one I selected.
I tried this procedure on more computer and this bug always seems in Flowcode 8.2.0.12 version.
Please try it out.
Change channels and set up ports over and over again.
I hope you will see the bug I wrote about.
Best Regards,
Lagoda
I have a problem with the PIC32MZ2048EFM100 MCU, UART component Remap Pin settings.
Bug Description:
First I create a new project and only add one UART (RS232) component to the 2D dashboard.
Then I try to configure TX and RX Remap Pins, but the "Properties" window shows the wrong ports for the selection.
If I choose an other channel and try to set again a TX and RX ports, then first, a different port name will be added to the table than the one I selected.
I tried this procedure on more computer and this bug always seems in Flowcode 8.2.0.12 version.
Please try it out.
Change channels and set up ports over and over again.
I hope you will see the bug I wrote about.
Best Regards,
Lagoda