Cool idea when working with small chips!!
Moderator: Benj
-
- Posts: 95
- Joined: Sat Jun 11, 2011 4:12 am
- Has thanked: 87 times
- Been thanked: 31 times
- Contact:
Cool idea when working with small chips!!
I have been popping in and out small 8 pin chips from EB006 to my proto units and came up with a very user friendly way of doing it without the use of tools. Try it you will like it!!
- Attachments
-
- 2012-01-16_14-55-16_783_800x450.JPG (35.59 KiB) Viewed 4049 times
Werner
STUDENT OF: Martin - Professor of Flowcode, John, Jan, Fotios and Nicolas "Spanish Dude"
STUDENT OF: Martin - Professor of Flowcode, John, Jan, Fotios and Nicolas "Spanish Dude"
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Cool idea when working with small chips!!
That is a good idea!
I usually can't find a screwdriver to prise out chips when I need 1.
That soves that problem.
Thanks
Martin
I usually can't find a screwdriver to prise out chips when I need 1.
That soves that problem.
Thanks
Martin
Martin
-
- Posts: 438
- Joined: Mon Aug 29, 2011 12:26 am
- Location: arizona
- Has thanked: 175 times
- Been thanked: 173 times
- Contact:
Re: Cool idea when working with small chips!!
neat concept, i bet if the tape was on the bottom in a fashion where it couldnt short the pins (not sure of dielectric value) you could have a lifting tab on each end to lift out 28 and 40 pin chips easily, im fond of my black heatshrinked screwdriver but like martin says its hard to find the thing when needing it