Hello
After programm with pickit3 my board wait in reset........
In the newest "readme" i found -L (after programming run) all work ok.
Also i read in a 64bit system there are problems....
5. Known Problems
----------------------------------------------------------------------------
ICD3-243: PK3CMD does not work on 64-bit OSs. The issue is that
if the command line tool has to switch firmware versions, it will not be
able to do that as it times out early.
Workaround: Download the correct firmware for the device using MPLAB IDE.
Once that is done the command line utility will detect the device.
In the V5 folders is a old one of readme
Regards Wolfgang
pickit3 programmer
Moderator: Benj
-
- Posts: 714
- Joined: Wed Jan 31, 2007 12:41 pm
- Has thanked: 1 time
- Been thanked: 26 times
- Contact: