16x1 LCD GENERIC 8 First Character..next 8 Character

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

User avatar
Posts: 666
Joined: Mon Feb 10, 2014 4:59 am
Has thanked: 494 times
Been thanked: 188 times

16x1 LCD GENERIC 8 First Character..next 8 Character

Postby Rudi » Thu Apr 03, 2014 11:42 am


i am now working at the LCD side.

I have found a little thing that have me make at begin with the work confuse.

For my Board I have setup a Generic 16x1 LCD at PortB0 ( 8 Databit ) with Register Select PortA.1 and Enable PortA.2

In First time i simple make a initialise at start by call the macro "Start"

Then i PrintString("Hello World") and wounder me why only the first 8 character was showing.

So i have seen the Macro Call "Cursor"... i think by myself that must i do to go on to the 9 Character pos and make two sending strings..

PrintString("Hello Wo")
This was running in Simulation but the string was "Hello Wo rld!"

i change it to
PrintString("Hello Wo")

This runs in Simulation well..but
this don't do the job in Hardware..
so i test the Macro Command...

PrintString("Hello Wo")
Command(0x0c0) ..........// This is a command usually go on at 9. Char...for me at this LCD i have this run for me... pls check it in your hardware description before you use it....


Hello World!


If someone has a Tip for this to make the strings comfortable as i do please let me know..
i am new in this ;-)...

Thank You!

Best wishes




I have test a other way at this..

the appropriate memory addresses for the 16 characters are 00h - 0Fh. This should be initialized as a 1-line device. First 8 characters are at 00h - 07h and the others are at 40h - 47h.
This can be initialized as a 2-line device.... After writing the first 8 characters, the cursor is moving at the location 40h (9th charachter) using my command: 0C0H for my LCD...
many LCD are compatibel but... is not so practikabel because all manufactory are not allways the same...so i have set the 16x1 in first example as a 1 Row - 16 Columns LCD...

...now i have set the 16x1 LCD as a 2 Row - 8 Columns LCD

so i can write the first 8 Character in "line1" ... this are the Character 1-8
and write in seconde line the next 8 Charcter in "line2" .. this are the Character 9-16
by simple calling the macro Cursor(x,y) and i do not remember me for calling commands by hex like Assembler..

so simple..

PrintString("Hello Wo")
Cursor(0,1) // <- ................................// this make the cursor to the secon "line" .. i configured the character 9-16 as a second line in LCD Properties..


Hello World!
These users thanked the author Rudi for the post:
Benj (Thu Apr 03, 2014 2:56 pm)
Rating: 5%