I recently purchased the ECIO40P16 and want to use its PWM functionality.
The datasheet and flowcode do not indicate which pins allow the use of PWM.
Just wondering if anyone would have more information on the chip?
Thanks in advance!!
ECIO40P16 PWM Pins
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: ECIO40P16 PWM Pins
The dsPIC has remap able pins that is the reason that the PWM is not shown tied to a specific pin
Place a PWM component on the Dashboard >> click on it and go to the properties panel
then see PWM >> remap pin select your pin from the popup menu
You will find the where the pins can map to in the datasheet()microchip) under Remap able Pin section
Place a PWM component on the Dashboard >> click on it and go to the properties panel
then see PWM >> remap pin select your pin from the popup menu
You will find the where the pins can map to in the datasheet()microchip) under Remap able Pin section
- Attachments
-
- 1.jpg (19.54 KiB) Viewed 3361 times
-
- 2.jpg (88.9 KiB) Viewed 3361 times
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR