Hi
This is regarding the example flowcode files in flowcode4 pro cd.I tried to compile the example "Single servo motor control" file to a hex file.But it says failure.Any suggestions to fix that.
Mario1
Unable to compile to Hex
Moderator: Benj
Unable to compile to Hex
- Attachments
-
- 1. Single servo motor control.fcf
- (5.5 KiB) Downloaded 227 times
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Unable to compile to Hex
Hi Mario1,
Although you have not got servo connected to any ports, the main reason for failure is:
You will need to use a microcontroller with 2PWM channels (it uses CCP part of PWM) e.g 16F883, unlike 16F88 which only has one.
Same question was asked here:
http://www.matrixmultimedia.com/mmforum ... 990#p23982
Martin
Although you have not got servo connected to any ports, the main reason for failure is:
You will need to use a microcontroller with 2PWM channels (it uses CCP part of PWM) e.g 16F883, unlike 16F88 which only has one.
Same question was asked here:
http://www.matrixmultimedia.com/mmforum ... 990#p23982
Martin
Martin