/* test program for EB006 + EB083 development platform */

#include <xc.h>

// CONFIG1
#pragma config FOSC = HS        // Oscillator Selection (HS Oscillator, High-speed crystal/resonator connected between OSC1 and OSC2 pins)
#pragma config WDTE = OFF       // Watchdog Timer Enable (WDT disabled)
#pragma config PWRTE = OFF      // Power-up Timer Enable (PWRT disabled)
#pragma config MCLRE = ON       // MCLR Pin Function Select (MCLR/VPP pin function is MCLR)
#pragma config CP = OFF         // Flash Program Memory Code Protection (Program memory code protection is disabled)
#pragma config CPD = OFF        // Data Memory Code Protection (Data memory code protection is disabled)
#pragma config BOREN = ON       // Brown-out Reset Enable (Brown-out Reset enabled)
#pragma config CLKOUTEN = OFF   // Clock Out Enable (CLKOUT function is disabled. I/O or oscillator function on the CLKOUT pin)
#pragma config IESO = OFF       // Internal/External Switchover (Internal/External Switchover mode is disabled)
#pragma config FCMEN = OFF      // Fail-Safe Clock Monitor Enable (Fail-Safe Clock Monitor is disabled)

// CONFIG2
#pragma config WRT = OFF        // Flash Memory Self-Write Protection (Write protection off)
#pragma config VCAPEN = OFF     // Voltage Regulator Capacitor Enable (All VCAP pin functionality is disabled)
#pragma config PLLEN = OFF      // PLL Enable (4x PLL disabled)
#pragma config STVREN = ON      // Stack Overflow/Underflow Reset Enable (Stack Overflow or Underflow will cause a Reset)
#pragma config BORV = LO        // Brown-out Reset Voltage Selection (Brown-out Reset Voltage (Vbor), low trip point selected.)
#pragma config LVP = OFF        // Low-Voltage Programming Enable (High-voltage on MCLR/VPP must be used for programming)


int main (void)
{
    ANSELA = 0x00;                  //Set PORTA to Digital Mode - Defaults to analogue mode
    OPTION_REG = 0xC0;
    TRISA = 0xF0;                   //Set A0-A3 as outputs
    TRISB = 0xF0;                   //Set B0-B3 as outputs
    
    int i;
    
    while (1)                       //Loop forever
    {
        LATA = 0x0F;                //A0-A3 on
        for (i=0; i < 32000; i++);  //delay
        
        LATA = 0x00;                //A0-A3 off
        for (i=0; i < 32000; i++);  //delay
        
        LATB = 0x0F;                //B0-B3 on
        for (i=0; i < 32000; i++);  //delay
        
        LATB = 0x00;                //B0-B3 off
        for (i=0; i < 32000; i++);  //delay
    }

    return 0;
}