Matrix - Why is my EB005 LCD E-block not working?
4 users online | 4 Guests and 0 Registered

Why is my EB005 LCD E-block not working?


Hardware - EB005 LCD E-Block



Symptoms -


- LCD not working

Problems -


- LCD may have not been initialized,
- Contrast may be turned down,
- +5V Power may be wired incorrectly,
- E-Block D-Type Connector may be loose,
- Low Voltage Programming may be enabled,
- Microcontroller program may be running too fast.

Solutions -


- Make sure that the LCD is initialized eg use the flowcode LCD start macro.
- Make sure that contrast isn't too low or too high, you should be able to see faint blocks when you switch on the device.
- Make sure that there is a wire connecting '+V Out' of the MultiProgrammer to '+V' on the LCD E-Block.
- Check the E-Blocks D-Type is plugged firmly into the MultiProgrammer.
- Disable Low Voltage Programming in PPP.
- Make sure that the microcontroller is running at the correct speed.

Last update:
2015-03-31 12:05
Author:
DavidA
Revision:
1.0
Average rating:0 (0 Votes)

You cannot comment on this entry

Chuck Norris has counted to infinity. Twice.

Home | Website Disclaimer | Returns Policy | Privacy Policy | Copyright Matrix Technology Solutions Ltd 2019
Chinese German Spanish French Greek Italian Dutch Russian Google translations