Matrix - Getting started with Flowcode and the BL0055 Arduino Eblocks 2 board
10 users online | 10 Guests and 0 Registered

Getting started with Flowcode and the BL0055 Arduino Eblocks 2 board


This FAQ will cover three things:

1. Installing the Arduino and Eblocks 2 drivers

2. Plugging the device into your PC

3. Setting up the board within Flowcode

 

1. Installing drivers

 

ARDUINO: Existing Arduino users should already have the relevant Arduino drivers installed. However if you do not have the drivers installed, you can download the driver folder here:

 

https://www.matrixtsl.com/resources/getresource.php?id=1120

 

To check whether your Arduino driver is working correctly, plug your Arduino device into your computer and go to your computers Control Panel and then Device Manager and it should show something like this:

 

 

EBLOCKS2: You can download the latest E-blocks 2 drivers from the link below, and simply run the relevant executable installer.

 

https://www.matrixtsl.com/resources/getresource.php?id=1121

 

Once again check your Device Manager to see if the Eblocks 2 is working, plug the device in (see step 2. if unsure how) and it should look something like this:

 

 

2. Plugging in the device

 

 

The picture above shows two USB plug in points:

 

Point A: This plug in point can be used to power the device when programming is not required, however if programming of the Arduino device is required this cable MUST be plugged in to allow programming of the Arduino.

 

Point B: This plug in point can also be used to power the device when programming is not required, however it CANNOT be used for programming the Arduino. It is however required when using the Eblocks 2 debugging tool 'Ghost'.

 

So in summary:

A:

  - Power

  - Programming

 

B:

  - Power

  - Debugging

 

3. Setting up the board within Flowcode

 

First thing is to select the appropriate Arduino device within Flowcode:

 

 

1. Select the ARD (Arduino) Chip Pack

2. From the dropdown select "Misc"

3. Select the BL0055 device

 

Next make sure to setup the Arduino device as a target, ensure the device is plugged into USB connection point 'A' in step 2, and then go to Build >> Project Options in Flowcode.

 

 

Where it says "Programmer Port", ensure that the Arduino device is selected.

 

You should now be good to go!

 

 

 

 

 

Last update:
2018-07-11 13:04
Author:
DavidA
Revision:
1.0
Average rating:0 (0 Votes)

You cannot comment on this entry

Chuck Norris has counted to infinity. Twice.

Home | Website Disclaimer | Returns Policy | Privacy Policy | Copyright Matrix Technology Solutions Ltd 2024
Chinese German Spanish French Greek Italian Dutch Russian Google translations