Search found 5 matches

Return

by beambase
Fri Oct 12, 2012 8:35 am
Jump to forum
Jump to topic

Re: CAN Bus Programming

Hello during the years I have developed some practical knowledge about CAN bus cabeling in industral systems focused on safety and there are some rules that should be folloed: 1 Cabeling I normaly use a cable with one data pair for the CAN bus and one pair to supply 24V bus power to the nodes. By us...
by beambase
Mon Dec 10, 2012 12:11 pm
Jump to forum
Jump to topic

Re: AVR using TRIAC

Hello
post a drawing of your hardware on the forum when it is ready and I will have a look at it.
by beambase
Tue Dec 11, 2012 11:21 pm
Jump to forum
Jump to topic

Re: AVR using TRIAC

Hello I don't fully understand how you are going to use the triac and how you will control them or what the circuit will do or look like in the end. But as I understand it you willuse the triacs to drive or feed different windings i a transformer. Maybe you alreday donethis but my experience is that...
by beambase
Thu Dec 20, 2012 10:57 am
Jump to forum
Jump to topic

Re: AVR using TRIAC

Hello, I think that we need some more info on the tranformer before we can do a culculation on number of turns etc. As i understand it is a autotransformer design you are looking for? What is your maximun supply Voltage? How many steps at what voltages do you need? How many Amps do you want from it?...
by beambase
Tue Aug 13, 2013 1:35 pm
Jump to forum
Jump to topic

Re: Millivoltmeter!

If you need better accuracy or lower mV reading have a look at this circuit: http://www.elektor.com/magazines/2013/july-047-august/accurate-universal-measurement-interface.2494505.lynkx It is easy to get it to work in Flowcode,I have some code if you are interested. But if you choose this hardware i...