Search found 6 matches

Return

by medelec35
Fri Feb 10, 2012 5:09 pm
Jump to forum
Jump to topic

Re: 12bit ADC in dsPIC?

Hi beambase, If you use ReadAsInt, then if 10 bit then Maximum value would be 2y(10)-1 = 1023. If 12 bit then maximum value should be 2y(12)-1=4095 Which is what I get in the simulation. Read 12bit ADC.png Not tried on hardware yet. For people using PIC, there are also some of PIC devices that use 1...
by saschech@gmx.de
Sat Mar 17, 2012 6:54 pm
Jump to forum
Jump to topic

Re: dsPIC EEPROM

Hello beambase I dont no,the v4dspic have these updates inside.... I have these files become in the beta-phase Inthe moment,I work with a 30F6012A with no probs on eeprom(only adr. 0 work not correct) rename the org-files to xxx.xxx_org and copy the updat files in the folder,so you can change alltim...
by Benj
Tue Apr 17, 2012 9:29 am
Jump to forum
Jump to topic

Re: gLCD 4D Macro does noot compile

Hello,

We have a full update release on the way but for now here are the files to get you up and running.
by Enamul
Tue Oct 30, 2012 1:31 pm
Jump to forum
Jump to topic

Re: dsPIC gLCD speed change

OK..right. Do you know what is the BUS type..if that is 0 in that case speed code part will not work..
#if (gLCD_1_MX_GLCD_BUSTYPE != 0)
by Mikat
Fri Mar 15, 2013 4:14 pm
Jump to forum
Jump to topic

Re: dsPIC 5.5 Internal CAN problem

Hello after upgrading to the latest dsPIC 5.5 version I was not able to compile my CAN projects created in 5.4. The CAN signal would be full of errors and I was not able to transmit anything that any other CAN diagnostic tool could read. Can you test that you set the CAN bus rate 4x higher than it ...
by prasha920
Sat Oct 26, 2013 5:43 pm
Jump to forum
Jump to topic

Re: Custom 7Segment display characters

Hi Martin, thanks a lot for clearing me where to post the files... :D Hello, I am looking to do the same thing. If you have a modified 7 segment LED component, can you please post the code? yes surely i am going to upload the corresponding files in my next post.. as mentioned by Martin, you will fin...