Search found 3 matches

Return

by JohnCrow
Thu Oct 06, 2011 6:19 pm
Jump to forum
Jump to topic

Re: GLCD EB058

Hi James Ive only used the display with a 16F877A chip, which works fine. Looking at the e-block data sheet you need to move the jumpers on the glcd board from the default settings to position A Other things to check 1) The EB058 e-block needs to be connected to 14V output on the programmer, unlike ...
by JohnCrow
Thu Oct 06, 2011 10:00 pm
Jump to forum
Jump to topic

Re: GLCD EB058

Hi Had a quick look at the flowchart, it looks ok, but I dont have time to set up the hardware tonight. Yes you are right with the flowcode macro only shows the CS line now in the latest version, but sounds like you have the hardware setup correctly. Only thing I can see might be causing it is in th...
by kersing
Sun Mar 30, 2014 8:47 am
Jump to forum
Jump to topic

Re: MX029 - GSM Remote Control

In the sim900 manual it says enter - at+cpbw,"99999",129,"fredbloggs" But in flowcode I have to write "at+cpbw,99999,129,fredbloggs" (is this the issue why) if yes then how can I send the above, flowcode will not let me. Hi James, Could you try entering \" (backsl...