Search found 3 matches

Return

by ARM
Tue Oct 20, 2015 8:20 pm
Jump to forum
Jump to topic

Re: external Interrupts on ARM devices doesn´t work

Hello, I´m sorry but I think it was a mistake. In the Atmel datasheet of AT91SAM7s UART0 was connected to Port PA5 and PA6 and UART1 was connected to PA21 and PA22. In Flowcode UART0 of the microcontroller was declared as channel 2 and is connect to PA5 and PA6. So UART0 is actually Channel 2 in Flo...
by ARM
Sat Mar 05, 2016 3:38 pm
Jump to forum
Jump to topic

Bugs in UART and SPI Master and TCP/IP components

After installing FC V1.3 i got following Bugs. -->UART1 INT no function. Same Error like FCV 1.2 (reported in 2015). --> SPI MAster Mode 0,3 Pin clocking failure: - SPI communication to MCP23S17 is OK. - SPI communication to WIZnet W5100 or WIZnet W5500 not possible, because the single bits are in M...
by ARM
Mon Mar 07, 2016 7:00 pm
Jump to forum
Jump to topic

Re: Bugs in UART and SPI Master and TCP/IP components

Hello, UART1: when enabling UART1 in Macro "SYS_initialise peripheral" (enable 2 Macro calls) and set PA 21 (RXD1) to ground, SPI COM to mcp23S17 and UART0 crashes. You can use the Project "Test_35" or "Flowcode check" SPI: SPI COM to W5500io/WIZ810MJ was tested with &q...