Search found 7 matches

Return

by Benj
Wed Apr 06, 2016 9:33 am
Jump to forum
Jump to topic

Re: bluetooth hc05

Hello,

The HC05 will work great with the ECIO40P. Flowcode v5 doesn't show the TX and RX pins but does use them, you can ignore the RTS, CTS pins as the HC module doesn't have flow control.

The TX/RX pins should be C6 and C7 on the ECIO device.
by medelec35
Wed Apr 06, 2016 10:36 pm
Jump to forum
Jump to topic

Re: Measurement of temperature and relative humidity using D

Hi paridhi, The errors are caused because ECIO-40 has a 16bit timer0 but the V5 flowchart was designed for 16F877A which has a 8bit timer. Therefore all the C code blocks referring to tmr0 will produce an error. You could use timer2 instead of timer0 and change all tmr0 to tmr2 . Also when changing ...
by medelec35
Fri Apr 15, 2016 2:21 pm
Jump to forum
Jump to topic

Re: Measurement of temperature and relative humidity using D

Must be camera angle then.
But A0 should be 4th socket along and looks like nothing in 4th, but red wire in 5th (A1)
Unless GND in in socket 2 in stead of socket 1 of bread board?
Can't tell from pic.
Just going over everything.
What's the colour bands on resistor?
by medelec35
Fri Apr 15, 2016 2:15 pm
Jump to forum
Jump to topic

Re: Measurement of temperature and relative humidity using D

paridhi wrote:shows Delay_count 1. Also the clock speed is 48MHz.

Confused with that.
The flowchart shows :

Code: Select all

Delay = 25

Also not sure if its the camera angle or not, but it looks like connection to DHT11 is going to port A1 and not port A0?
by medelec35
Fri Apr 15, 2016 8:09 am
Jump to forum
Jump to topic

Re: Measurement of temperature and relative humidity using D

I tried my DHT11 with ECIO40p and I got the humidity and temp displayed OK with the non timer interrupt version.
Are you referring to ECIO-40p Eblock?
by medelec35
Fri Apr 15, 2016 1:31 pm
Jump to forum
Jump to topic

Re: Measurement of temperature and relative humidity using D

Hi paridhi, To make sure, I have downloaded DHT11v1.01 No timer interrupt.fcf from a couple of posts above. Changed target to ECIO-40 Re- programmed ECIO-40p and got the following: ECIO-40P.jpg If you are using with a separate 18F4455 and not ECIO-40p then the clock speed must be 16MHz or above. If ...
by medelec35
Fri Apr 15, 2016 3:05 pm
Jump to forum
Jump to topic

Re: Measurement of temperature and relative humidity using D

paridhi wrote:Sorry, I wasted your time.

Please don't think that.
You have not wasted my time at all.
I'm here to help.