Search found 8 matches

Return

by Quartz
Mon May 22, 2017 10:39 pm
Jump to forum
Jump to topic

Re: 24FJ128GC006 Support

Wow! Thats support! I have put them in the directories you said to put them. I'll be able to get my teeth into this Wednesday or failing that by the week end so I'll have a look and get back to you with how I get on. There is now another thing that hopefully just information could get me sorted but ...
by Quartz
Wed May 24, 2017 6:03 pm
Jump to forum
Jump to topic

Re: How to use own fonts with GLCD ST7565R component

Thanks again for your help, All the information is there in the links, I just got a bit tied up looking for stuff that wasn't there or was for a previous version or was shouting at me and I just couldn't see it. I can work things out, eventually.. :-) I'll have to load up the font set I have and see...
by Quartz
Sat Sep 09, 2017 11:02 am
Jump to forum
Jump to topic

Re: Compiler options settings locked

Hi

Brilliant, just that alone sorted me out!

I was trying to build on the Curiosity board stuff and after reading your reply I changed the selected chip and I can now edit the location etc...


Found what I need to do now many thanks for your help.... Again.
by Quartz
Tue Oct 03, 2017 8:10 pm
Jump to forum
Jump to topic

Re: PIC24FJ128GC006 RF7 unuseable

Hi Thanks for that I'll give it a go later today. I understand what you say about the datasheet but I can't explain why it's not correct. I have a board populated with a PIC24FJ128GC006 and a gLCD with a Red, Green & Blue LED backlights, one of which is connected to pin 34 (VBUS) and using that ...
by Quartz
Tue Oct 03, 2017 9:48 pm
Jump to forum
Jump to topic

Re: PIC24FJ128GC006 RF7 unuseable

Hi Benj I have used the new chip definition file in FC7. On the PIC24FJ128GC006 I used port F7 to flash a led, I programmed the chip from FC7 and the code works fine with that port pin thank you. I'm trying to get to know the chip and the board it's on so that I can reprogram it to do some of the th...
by Quartz
Mon Dec 04, 2017 7:28 pm
Jump to forum
Jump to topic

Generic I2C Component

I understand that component creation is possible through a step by step walk through of a tutorial or video but having wanted to control various I2C chips I found it very confusing and not easy! I have yet to be able to create one to control a MCP23008 or a MCP3221. How about..... An I2C component t...
by Quartz
Fri Dec 08, 2017 2:22 am
Jump to forum
Jump to topic

Re: Generic I2C Component

Hi Benj Thanks for the link, it just shows that almost everything is there, if you know where to look.... :-) I did have a look at the I2C master component before and didn't get very far, the link could make all the difference. And having looked around for examples / help I only found stuff that was...
by Quartz
Fri Dec 08, 2017 4:20 pm
Jump to forum
Jump to topic

Re: Generic I2C Component

I have realised I didn't explain some of the picture... In the picture those command entries with an enable tick box next to them are drop down selection boxes that have the various commands like Start, Restart, Stop etc in each so that the user doesn't have to work out what they can use it's in fro...