Matrix user forums

hello steve

thank for your concern.
these link is about enough to me to getting start..

thank you

hi,

thanks ben, I will try to evaluate it..
but basically I want to build that wireless communication for replace the old one using RS485 com so no more cable to use. Could that zigbee suitable for this?

Not sure for this, but I hope I can send at least a switch on/off command and some additional time code like hh:mm:ss through to all slaves

Hi, guys, I want to build a wireless network for a building at least 250m range. here is my goal... I want to build one master with multiple slave.. Master will transfer all the information to whole of slave while slave is only "listening". the problem is I don't know how I must start.. what e-block...

Hi,

Assuming that you are correct on the Vnet setup,
I have a Simple program that fully worked and Simulated by the Vnet server on my computer.

try them and let me know then.
Hope you have some idea cheers

Gumilard

should be work tomorrow thanks.

Sorry, I forgot to upload my code yesterday

here we go

I'm using fcv5.5.2.1 is it updated? error occur when I compile them into hex file. Yes I hope the UART can work separately because I configure the HW UART to receive gps information then I use the software uart to send some data to another pic micro.

HI.. Not sure this topic has ever asked before. I want to using RS232 soft mode simultanously with Hardware Uart with PIC16F877A@20Mhz. The simulation is good. But whenever I build into hex file, the error message appears. btw I use the Hardware UART to moderated the GPS/GSM module as I need the rel...

Hi,

Thanks. Would be great in january.

Cheers..

Hi Take a look at this http://www.matrixmultimedia.com/mmforums/viewtopic.php?f=29&t=10967&p=37498&hilit=AD9833#p37498 now, I am trying to figure out how the dsPIC can generate the sine wave it self without DDS chip. For that I've tried using pwm output with 256 LUT data resolution. After I applied ...

Hi

Enamul

Oh yea, and about the INT variable, if so my project would not be able to be made? because I hope I can generate 0.01 Hz until at least 2 MHz. Is it possible to me If I use the FCV5 now?

regards,
Gumilard

Hi

Enamul,

I have just downloaded the code, and I will try and it look interesting to me and inform to you..

thanks
Gumilard

HI Enamul Wait.. wait... I can open it Now. Sorry :D I'm using FC V4.5 OK, first I don't see anything on my scope.. I do a little change on the SPI Configuration: Fosc/4 changed to Fosc/16 change clock polarity Idle_low changed to Idle_high and I just want to say WOW ! it's work just fine :D I can s...

Hi Enamul.

Wow bit seem light to me thank you. but Why I can't open that Flowcode in my computer?? that will given error message.

cheers
Gumilard

Hi Benj,

Please see my attachment. Look at my calculation code, is that same with what you said?

Hi Enamul,

Ok, I will waiting patiently

thanks for your time all


Cheers
Gumilard