Matrix user forums

Dear Steve,

Thanks a lot, (also for your quick response)
THIS WORKS, GREAT!

With kind regards,

Reinier

I have also a connection problem with EB 006-00-7 using FC4 with also PPP v3.9. This problem reased when I renewed my PC with Windows 10x64. Compiling to a PIC under my old Windows 7 x64 was never a problem. But installing the PPP driver "DPInstAmd64.exe" it failed under Windows 10. Recently, I read...

Dear Benj, Unfortunately, I have the same behavior with the try version of flowcode 8. Only the 4 UID bytes will be given properly, but other data is not clear for me. I Did not understand. I Tried with several Mifare 1k card and a tag. Especially the BCC check of byte 5 is good to show the mismatch...

Dear Benj, There are no any problems with the hardware connection. I use a PIC 16f1937 and a 3,3volt level separator of the MFRC522 board. I tried your new routine and see that I can display the 4 bytes [0 to 3] of the UID of a 1k Mifare card as well. (compare it with my eb052) . This sounds good! B...

Hi Benj, Is there any solution to use the new RFID_MFRC522.fcpx component for Flowcode v6 ? In August of 2016 I find also bad data with the component RFID_MFRC522.fcpx component using the Arduno board. (I will use to program a PIC 16f1937 with a multi programmer eb006) I'm happy that there is a new ...

Hi Enamul,

Thanks for your quick reply. I'm interesting into your experiences

Thanks,

Reinier

Dear Enamul, David ... Perhaps this topic is not specific the 18f4680 but I tried again to program a 16F chip to use ICD . I study again the connection and checked all by DMM : all looks fine. The custom board with the PICmicro is very simple (Res of 10k MCLR to VDD : acc. spec , VDD is comming from...

Dear David, I had a comparable problem with ICD and my EB006-00-7. I tried to flash a (simple) 16F88 directly with the 16F88 socket on the board. (Of course , I wired MCLR , PGD, PGC , + 5V and GND correctly to my custom PCB with a self made cable) To avoid conflcts, I was very careful with circuit ...