Matrix user forums

Hi Guys,

would somebody be kind enough to have breeze over my code, using version 4, have the circuit built but having tuning problems, works fine without feedback so guessing the ciruits ok and possible a problem with my code which i can not find. thanks

Hi Benj,

can't seem to open your examples you posted on PID control. would it be possible for you to repost them as I cant use the new dsp as i only have access to version 4 and my project has stalled
thanks

tanks daz, I will check that out, mite not be able to wait due to time constraints,but do you know when it will be relased and how will i access it once it is?

thanks

I will send info and pictures to your email as could not post it here.

Sorry I was not very clear in my last post; 220 V AC is the mains power for the feed back rig itself. The motor it self is 24 volt DC. With a nominal current of 1A and generates 16W. The rig has an input for the signal to the motor, a + and -15 volt Dc output and an output from the tachometer.

Hi what I meant was I applied a 5 volt signal to the motor and measured the voltage I was feedback from the tachometer which was 1.7 volts. the motor I am using is a feedback rig with tachometer attached, here are the specs I found; DC MOTOR: VOLTAGE: 24V NOMINAL CURRENT: 1A TORQUE CONSTANT: 0.06 Nm...

The motor is 0 -24 volts 16 watt. And the techo is feeding back a voltage of 5 volts at full speed

Thanks guys I will start off with some simple control and progress from there as you suggested Enamul, I will let know how I progress

Kkkk

have not tried the solution you suggested yet as that was happing in the lab on flow code version 4, I am also trying to compile the same simple programmes at home from my laptop to the E-Blocks using flow code version 5 the free version, and this time I am getting an error saying "USB not connected...

Thanks for the help Ben I will give that a shot

Hi I'm a student new to flow code, I have a project to do using a PIC and PID control of a motor, at the moment I am using E-Blocks, just trying some simple programmes with an LCD and Keypad but whenever I try to compile to the chip I get the following message " unable to transfer the HEX file using...