Matrix user forums

Hi John, Sorry that was a mistype not the settings I had in the program. I have the 16f88 working on both the glcd and the eb063 433 meg boards, but the 16f877a did not work on both of these, wonder if settings are a miss ? I have noticed that when using the matrix program board they say you must ha...

Hi Sean, Thanks for the reply and help. The 16f88 works fine no probs, have modified the program now comms nice and consistant. My only problem is the 16f877a does not work, I noticed you have sent an example 16f877 which has different pin connections to the EB063 ? I have the program counting every...

Hi, Has anyone succesfully got 2 of these units working together, if yes please can I hear from you and how you did it, the example in matrix web site does not work in my house. I purchased 2 brand new 16f877a chips today to make sure no issues with mcu, the hardware has also been checked using lcd ...

Hi,

Compiles but does not run, using the patch to marry the pins on the E blocks eb058.

Using v4.5 flowcode

ports in use -

d0 = cs
d1 = sdo
d2 = sdi
d3 = sck

Anyhelp would be grateful

Regards
james

Hi,

Compiles but does not run, using the patch to marry the pins on the E blocks eb058.

Using v4.5 flowcode

ports in use -

B1 = SCK
B0 = SDI
C7 = SDO
C0 = CS

Anyhelp would be grateful

Cheers
James

Hi John,

Just to confirm:

C0 = CS
C3 = sck
C4 = sdo
C5 = sdi
Jumper in B position
with the 16f877a



Cheers
James

Hi John,

Might be the spi port not working on the 16f877a I found yesterday when I thought I had none, it's been tossed around from place to place so don't know if it's fully working will try another chip like 18fxxxx, got a few so will have a go.
Thanks for your help anyway John.

Regards
James

Hi,

Have succesfully used the 16f88 with the gLCD Module EB058, unfortunatly have come a bit stuck with the 16877a, checked all settings and program, can't see what has gone wrong, need some help if possible.
Program attached.
I am running v4.5 flowcode.

Cheers
James

Hi John,

Matrix should put on you on the pay roll, changing the mux pin from b0 to b3 did the trick.



Many Thanks John

Best Regards
James

Hi John, Thanks for the reply. :) The Chip is 16f88 as I have already mentioned. I'm using v4.5 which has the mod "c" file in it already. C0 is being used as the CS (chip select). with v4.5 you don't see the selections like "SDI or SDO" not sure if this is correct or not ? I have selected jumper "A"...

Hi,

Anybody succesfully used the GLCD, because I'm struggling getting it to work.

I have 16f88 and EB058 board.

Cheers
james