Matrix user forums

CAN in V5 is OK!
Thanks!

CAN2 in V5 is OK!
CAN in V5 is not yet! Effort to...

Problem solving it.
thank you

I use the software is V4.5. Hardware is: EB006- 6, CANbus EB018- 1. Use CAN macro, everything will be all right! The simulation and downloaded to chip in completely correct operation! But, the use of CAN2 macros. Vet simulation can't! Download to 16 F877A chip in normal operation can't! Help me! Tha...

I use a CAN E-block.

I use the Flowcode v5.2.0.0

I made a simple CAN bus, receive、send programs. In V4 download to chip in the running without any problems. But in V5 download to chip in after the correct operation but not! Why? Please help me!

My name is Dian Nie.This is what I write about the China's first "Flowcode V4" monograph. 《PIC microcontroller programming-the flow code based on Flowcode V4 flow code design platform》 This week by publishing house of electronics industry formally published and distributed across the country. Member...

In the Chinese and English in the interface of the generation of C code and ASM code is indeed the same! But their HEX file but have very big difference. The key is to download the chip results but not as after! The English can be a very good operation. The Chinese is really not line! You download t...

In the Chinese interface open this example, and download to chip problems will occur! You try!

I know the problem! English environment is no problem! I am using Chinese interface, will have the above problems! Chinese environment that bug! You can try Chinese interface case!
Thank you!

Have downloaded the update. But the problem still! Download to chip inside can't correctly operation! You try!

In v5, this switch control the light of the example has problems:
The simulation is good; But download to 16f887 chip, not the correct operation!

In v4,do not have any problem!
Please help me!

DavidA wrote:Hi,

This is working as intended, the CAN Init function has a while loop in it that waits for a valid CAN return message before it moves out of the initialiser icon, so, in other words, dont use CAN Init unless you are in a valid CAN network

Thank you very much!

I'm using the "CAN", discovered a problem, as long as "CAN Init" later, the simulation is possible. But after downloaded to the chip can't normal operation! Even reset also can't run. For example a flash。Please help me!

Flowcode V5.2
Use CAN macro, sending, receiving communication, in FlowServer cannot simulation.
The following example, please help me!

Flowing water light

EB064-1 development board U6 position is "PIC24F04KA201" type of chip.

You look at.

EB064- 1 development board has "PIC24F04KA201" type of chip. But in software "Flowcode V4 for PIC24 & dsPICmicros" that there were no this model of chip. , can't development! What reason is this? for help!

The chip is 16 F887, can finish all kinds of complex progression. The design is very convenient, it's interesting.

thank you!

Excuse me:
In "Flowcode_PIC16bit" software inside, DSP Library; Fixed Point Math Library; Floating Point Math everyday. Provide ? The new version will be? Thank you!