E-blocks 2 RFID Board (BL0197)
Posted: Mon Jul 15, 2019 4:27 pm
Hi,
There is a problem with the RFID BL0197 component. This component is not initialized.
The component was connected to the BL0011 Board to B and C ports.
I used the RFID (EB052, RWD MICODE) component in Flowcode 8.2 and tried to set up different ports (B and C) in the connection setup. I set the TX to pin 0, RX to 1 and CTS to 4 (as in E blocks 2 datasheet).
I also tried using RFID (MFRC522) component but it didn't work. Port connection settings are different from that in the datasheet., so I do not think that use this component is correct.
How to use these settings in the right way?
There is a problem with the RFID BL0197 component. This component is not initialized.
The component was connected to the BL0011 Board to B and C ports.
I used the RFID (EB052, RWD MICODE) component in Flowcode 8.2 and tried to set up different ports (B and C) in the connection setup. I set the TX to pin 0, RX to 1 and CTS to 4 (as in E blocks 2 datasheet).
I also tried using RFID (MFRC522) component but it didn't work. Port connection settings are different from that in the datasheet., so I do not think that use this component is correct.
How to use these settings in the right way?