Page 1 of 1

Outputs in panel

Posted: Mon Jun 10, 2013 9:12 pm
by wjhos
I have a strange problem when i place an output on the panel.
As soon as i replace it, the output (LED, RGBLED and LED array), the LED and the activation field are split!. So when i want to change fi the connection, right clicking the LED does not work, because the corresponding area is somewhere else. I can only find it by randomly clicking in the panel. This is very annoying. What can be the cause and remedy ?

Re: Outputs in panel

Posted: Tue Jun 11, 2013 5:32 am
by Kenrix2
I just did a search for "panel bug" and this post was listed which looks similar to your issue:
http://www.matrixmultimedia.com/mmforum ... bug#p24031
It is for V4 and no remedy but, the last entry has an easy work around. Give it a try, hit run then stop.
You could also download the V5 Demo and use it to see if the problem follows.

Re: Outputs in panel

Posted: Wed Jun 12, 2013 11:02 am
by wjhos
I downloaded FC5 to a new directory, but the phenomen remains. It only affects the LED icons !

Re: Outputs in panel

Posted: Thu Jun 13, 2013 1:27 pm
by Benj
Hello,

Sounds like an interesting phenomenon, certainly nothing I've ever experienced.
Out of interest what is your windows DPI set to?

Re: Outputs in panel

Posted: Wed Nov 06, 2013 9:55 pm
by wjhos
Hi,
Refering to the LED problem, i found a workaround to correct the strange behaviour. When i place an LED on the panel, i change the external properties from round to square or oval, and then back to round. After that i can move the LED over the panel whitout the LED and selection frame being split. Some hint to a solution ?