Microchip Programmer MPLAB SNAP

Tips, Tricks and methods for programming, learn ways of making your programming life easier, and share your knowledge with others.

Moderators: Benj, Mods

stefan.erni
Posts: 561
Joined: Fri Aug 19, 2016 2:09 pm
Location: switzerland
Has thanked: 181 times
Been thanked: 174 times
Contact:

Microchip Programmer MPLAB SNAP

Postby stefan.erni » Fri May 15, 2020 1:18 pm

Hi Ben

There is a cheap programmer for PIC's (less than 20$) and it's working fine with Flowcode 8

Just change to /TPSNAP in the
--compileroption
----programmer
-----parameter

like this:
/P$(chip) /F"$(outdir)$(target).hex" /TPSNAP /M /OL

I suspect this applies to all programmers in the same way

Following are the supported tool names (not case-sensitive):
• ICD3 – MPLAB ICD 3 In-Circuit Debugger
• ICD4 – MPLAB ICD 4 In-Circuit Debugger
• RealICE – MPLAB REAL ICE In-Circuit Emulator
• PICkit3 – PICkit 3 In-Circuit Debugger
• PICkit4 – MPLAB PICkit 4 In-Circuit Debugger
• SIM – Simulator
• PM3 – MPLAB PM3 Programmer
• LicensedDebugger – third party debugger
• LicensedProgrammer – third party programmer
• SK – Microchip Starter Kit (PICkit On Board – PKOB)
• SNAP – MPLAB Snap In-Circuit Debugger
• EDBG - Embedded Debugger
To set the tool for programming only, a space must precede the -p option.

Bild1.PNG
Bild1.PNG (248.61 KiB) Viewed 164 times
These users thanked the author stefan.erni for the post (total 3):
medelec35 (Fri May 15, 2020 1:52 pm) • Steve (Fri May 15, 2020 2:28 pm) • Benj (Fri May 15, 2020 10:45 pm)
Rating: 15%