MIAC with full bridge DC motor
Posted: Fri Jul 04, 2014 4:06 pm
Hi again,
I'm having a bit of trouble with the full bridge motor component. It works fine in simulation but not when downloaded to the MIAC. The transistor outputs aren't turned on at all, so the motor doesn't move. We've had no problem with steppers and half bridge dc motors, so for now I've written macros for controlling two half bridge motors for the same functionality, but obviously this isn't ideal.
I've attached a really simple flow code that shows the problem.
Anyone have any ideas?
Thanks in advance, Ben
I'm having a bit of trouble with the full bridge motor component. It works fine in simulation but not when downloaded to the MIAC. The transistor outputs aren't turned on at all, so the motor doesn't move. We've had no problem with steppers and half bridge dc motors, so for now I've written macros for controlling two half bridge motors for the same functionality, but obviously this isn't ideal.
I've attached a really simple flow code that shows the problem.
Anyone have any ideas?
Thanks in advance, Ben