Hello
I have now install Flowcode V4
CAN2 work now. The data work correct but not the identifier. The identifier
does not change. The identifier is not correct. It stay always up 688.
In attachement i have sent you the program.
What is it wrong?
Best regards
Nazaire
CAN2 component in flowcode V4
-
Nazaire VERRUE
- Posts: 43
- Joined: Tue Nov 23, 2010 4:46 pm
- Been thanked: 3 times
- Contact:
-
Sean
- Valued Contributor
- Posts: 548
- Joined: Tue Jun 26, 2007 11:23 am
- Has thanked: 6 times
- Been thanked: 44 times
- Contact:
Re: CAN2 component in flowcode V4
We have been able to reproduce your results and are looking into the problem.
-
Sean
- Valued Contributor
- Posts: 548
- Joined: Tue Jun 26, 2007 11:23 am
- Has thanked: 6 times
- Been thanked: 44 times
- Contact:
Re: CAN2 component in flowcode V4
Here is a new version of the PIC_CAN2.c file used by Flowcode for PIC V4. The extended address commands now operate correctly with MIAC.
This file needs to be copied to the Components folder of the Flowcode V4 installation - overwritting the original file.
This file needs to be copied to the Components folder of the Flowcode V4 installation - overwritting the original file.
-
Nazaire VERRUE
- Posts: 43
- Joined: Tue Nov 23, 2010 4:46 pm
- Been thanked: 3 times
- Contact:
Re: CAN2 component in flowcode V4
Thank you Sean
The CAN2 component in flowcode V4 work now perfect.
Regard
Nazaire
The CAN2 component in flowcode V4 work now perfect.
Regard
Nazaire