stepper motor not running correctly

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 4.
To post in this forum you must have a registered copy of Flowcode 4 or higher. To sign up for this forum topic please use the "Online Resources" link in the Flowcode Help Menu.

Moderator: Benj

Post Reply
nuwan5213
Posts: 82
Joined: Thu Jul 29, 2010 10:03 am
Location: sri lanka
Contact:

stepper motor not running correctly

Post by nuwan5213 »

Hi Friends,

My recent project is drawcord cutter and please find attached Flowcode.
im using SANYO driver and related motor can find below link

http://www.ebay.com/itm/Sanyo-PMM-BD-57 ... 3cdf4aed60

that controller has pulse input and in my flowcode im using C0 pin for that and it is high for 1ms and low for 2ms.
the problem is cutting pcs are not equal.

i was done the inspection on mechanical parts and it seems ok.

please advice,
regards,
nuwan.
Attachments
cutter3.fcf
(22.95 KiB) Downloaded 403 times
Electronics for better world.

Post Reply