Hi Friends,
My recent project is drawcord cutter and please find attached Flowcode.
im using SANYO driver and related motor can find below link
http://www.ebay.com/itm/Sanyo-PMM-BD-57 ... 3cdf4aed60
that controller has pulse input and in my flowcode im using C0 pin for that and it is high for 1ms and low for 2ms.
the problem is cutting pcs are not equal.
i was done the inspection on mechanical parts and it seems ok.
please advice,
regards,
nuwan.
stepper motor not running correctly
Moderator: Benj
-
- Posts: 82
- Joined: Thu Jul 29, 2010 10:03 am
- Location: sri lanka
- Has thanked: 24 times
- Been thanked: 4 times
- Contact:
stepper motor not running correctly
- Attachments
-
- cutter3.fcf
- (22.95 KiB) Downloaded 627 times
Electronics for better world.