Changing Target devices

Moderator: Benj

Post Reply
medelec35
Matrix Staff
Posts: 9520
Joined: Sat May 05, 2007 2:27 pm
Location: Northamptonshire, UK
Has thanked: 2585 times
Been thanked: 3815 times
Contact:

Changing Target devices

Post by medelec35 »

When changing target device:
Rather than a pop up window saying unable to run one or more commands, then flowcode refusing to change target until corrections are made. Would it be possible for Flowcode to change to different target then warn you?
Reason for this is if there is an icon to read the whole port A with masking on original target, and on new target whole of port A is not available, but whole of port E is, so can use that.
Flowcode will not allow me to change input from port A to port E because port E does not exist on the original target.
So I have to delete all icons (rather then just alter) associated with the confliction, before allowed to change target.
Martin

Post Reply