Component creation freelancer wanted.

For anyone wishing to receive additional help with a project or simply looking to hire an embedded contractor we have a few contacts who would be more then willing to help.

Moderators: Benj, Mods

Post Reply
headhuntergr
Posts: 50
Joined: Fri Feb 28, 2014 7:25 am
Contact:

Component creation freelancer wanted.

Post by headhuntergr »

Hello!
I am looking for someone to create me some components for flowcode V6, a display, a current sensor, a simple DAC, a ADC
I have datasheets if needed.


Regards

User avatar
JohnCrow
Valued Contributor
Valued Contributor
Posts: 1367
Joined: Wed Sep 19, 2007 1:21 pm
Location: Lincolnshire
Contact:

Re: Component creation freelancer wanted.

Post by JohnCrow »

Hi
Have you seen this current sensor component?

http://www.matrixtsl.com/mmforums/viewt ... 712#p51049
1 in 10 people understand binary, the other one doesn't !

headhuntergr
Posts: 50
Joined: Fri Feb 28, 2014 7:25 am
Contact:

Re: Component creation freelancer wanted.

Post by headhuntergr »

Yes already i presume the acs711 (wich might get dumped for precision reasons) i want to use is something similar.
For now i am skipping the rest and focusing more on the display which is the most complicated part.

User avatar
Benj
Matrix Staff
Posts: 14848
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Contact:

Re: Component creation freelancer wanted.

Post by Benj »

Hello,

What is the controller IC on the display and do you have a pin out? Might be an easy one to push through.

headhuntergr
Posts: 50
Joined: Fri Feb 28, 2014 7:25 am
Contact:

Re: Component creation freelancer wanted.

Post by headhuntergr »

Hello Ben!
The controller is SP9210, here is a datasheet i found http://www.displayfuture.com/Display/da ... SP9210.pdf

Regards

User avatar
Benj
Matrix Staff
Posts: 14848
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Contact:

Re: Component creation freelancer wanted.

Post by Benj »

Hello,

Ok thanks I will look into this. Do you know if the displays your looking at have the 6080 or 8080 type interface. If you have a datasheet for the specific display then it should help me to get the pin properties and the code correct.

headhuntergr
Posts: 50
Joined: Fri Feb 28, 2014 7:25 am
Contact:

Re: Component creation freelancer wanted.

Post by headhuntergr »

I am looking to use it with SPI interface (the serial interface).
Doesn't seem to be anything else regarding this controller. There is only one datasheet.

The actual pixel size of the display is 128 x 36 dots

Post Reply