Page 1 of 1
Component creation freelancer wanted.
Posted: Fri Dec 05, 2014 11:23 pm
by headhuntergr
Hello!
I am looking for someone to create me some components for flowcode V6, a display, a current sensor, a simple DAC, a ADC
I have datasheets if needed.
Regards
Re: Component creation freelancer wanted.
Posted: Sun Dec 07, 2014 1:00 pm
by JohnCrow
Re: Component creation freelancer wanted.
Posted: Sun Dec 07, 2014 1:57 pm
by headhuntergr
Yes already i presume the acs711 (wich might get dumped for precision reasons) i want to use is something similar.
For now i am skipping the rest and focusing more on the display which is the most complicated part.
Re: Component creation freelancer wanted.
Posted: Mon Dec 08, 2014 11:21 am
by Benj
Hello,
What is the controller IC on the display and do you have a pin out? Might be an easy one to push through.
Re: Component creation freelancer wanted.
Posted: Mon Dec 08, 2014 2:41 pm
by headhuntergr
Hello Ben!
The controller is SP9210, here is a datasheet i found
http://www.displayfuture.com/Display/da ... SP9210.pdf
Regards
Re: Component creation freelancer wanted.
Posted: Mon Dec 08, 2014 3:47 pm
by Benj
Hello,
Ok thanks I will look into this. Do you know if the displays your looking at have the 6080 or 8080 type interface. If you have a datasheet for the specific display then it should help me to get the pin properties and the code correct.
Re: Component creation freelancer wanted.
Posted: Mon Dec 08, 2014 4:51 pm
by headhuntergr
I am looking to use it with SPI interface (the serial interface).
Doesn't seem to be anything else regarding this controller. There is only one datasheet.
The actual pixel size of the display is 128 x 36 dots