Page 1 of 1
new project, need programmer
Posted: Tue Oct 06, 2009 2:37 pm
by inmedical
We are getting into PIC programming, but will take some time. Meanwhile a project has come up ( very basic), and would like to outsource the programming. If interested please contact me for more details.
Thank you,
David Campbell
Re: new project, need programmer
Posted: Fri Oct 23, 2009 3:56 pm
by Benj
Hello David
Did anyone get back in touch with your about helping out with your project?
Re: new project, need programmer
Posted: Fri Nov 06, 2009 6:09 pm
by djd
Hi David,
Firstly I must apologise for not getting back to you sooner.
I very rarely go on the Forum area of MatrixMultimedia website so I missed picking up your message.
I thought that the forum had been setup so that people could email the embedded designers (like myself).
I'll have to have a word with Ben about that.
Anyway, if you are still looking for some help/assistance please let me know.
Kind regards from David (Dempster)
My personal email address is
djd@teamwork-int.com
Re: new project, need programmer
Posted: Sun Aug 08, 2010 5:03 pm
by cantronicx
To Anyone,
I would like someone to help me on a Can-Bus issue using the Atmel (AVR) AT90CAN128 chip. Just need a little kick-start to get this project going. Presently using flowcode V4 for AVR and the support is getting weaker by the moment.
Re: new project, need programmer
Posted: Mon Aug 09, 2010 1:14 pm
by Steve
cantronicx wrote:Presently using flowcode V4 for AVR and the support is getting weaker by the moment.
I'm surprised at your comment about our support of Flowcode for AVR. I've just checked and your posts are getting answered. What more do you expect us to do?
Re: new project, need programmer
Posted: Mon Apr 18, 2011 5:17 pm
by greentech
I want someone to help me with decoding sony irda remote control, model cmy3a.
Re: new project, need programmer
Posted: Mon Jun 25, 2012 10:54 pm
by mzffr786
inmedical wrote:We are getting into PIC programming, but will take some time. Meanwhile a project has come up ( very basic), and would like to outsource the programming. If interested please contact me for more details.
Thank you,
David Campbell
Dear David
i see ur massage and i m intristing.i do many projects in flowcode programing.if u like i will make software and project make for u.more detail i will give u after ur reply.
my email add is
mzffr786@hotmail.com
reguard Muzaffar Mahmood