Hi Forum Community,
I use Flowcode 5 since some years for small, simple projects. I use a lot of DS18S20 - temperature sensors in some Projects. For a new project I need the high 16 Bit resolution of the DS18S20.
I try the example made from Benj in post number 13: viewtopic.php?f=29&t=8368&p=26668&hilit=ds18s20+12+bit#p26668
I attached this flowchart to this posting.
It works, but it works not good.
In high resolution mode, the DS18S20 should produce a multible of 0.0625:
What I get, when I warm up the sensor very slowly:
Jump to 32.000000
Jump to 33.000000
The Jump need a lot of time, cause i warm up the sensor realy realy slowly. It is enough time to show the correct values between x.437500 and jump to next higher degree (x+1).000000 but it is not.
I do not finde the problem in benj's code, maybe someone can help me.
Support-Forum für Deutschsprachige, die in ihrer Muttersprache schreiben möchten.
1 post • Page 1 of 1