Hallo
kann einer mir helfen, wie ein Atmega 8 beim Port B die Pins B6 und B7 als Ausgang schalten kann?
Ich benutze E-Blocks für AVR und der Flowcode 4.
Danke im Voraus
Luc
Atmega 8 port B Pin 6 & 7 als Ausgang
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Atmega 8 port B Pin 6 & 7 als Ausgang
Hallo Luc,
Ich denke, es ist möglich, diese Pins als Ausgänge verwenden, wie ich nicht finden können, was in dem Datenblatt sagt nichts anderes. Doch auf der EB019 E-blocks-Programmierer diese Pins an den Kristall fest verdrahtet und nicht auf die D-Typ-Anschluss gehen.
Hello,
I think it is possible to use these pins as outputs as I cannot find anything in the datasheet saying otherwise. However on the EB019 E-blocks programmer these pins are hardwired to the crystal and do not go to the D-type port connector.
Ich denke, es ist möglich, diese Pins als Ausgänge verwenden, wie ich nicht finden können, was in dem Datenblatt sagt nichts anderes. Doch auf der EB019 E-blocks-Programmierer diese Pins an den Kristall fest verdrahtet und nicht auf die D-Typ-Anschluss gehen.
Hello,
I think it is possible to use these pins as outputs as I cannot find anything in the datasheet saying otherwise. However on the EB019 E-blocks programmer these pins are hardwired to the crystal and do not go to the D-type port connector.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel