Page 1 of 1

Flowcode con PicKit 4

Posted: Fri Jun 01, 2018 12:58 pm
by MOCUELSL
Good morning, I just acquired flowcode 8 and I would like to know if it is possible to program with PicKit 4, I have seen that it can be configured for PicKit 3 but not for 4. Thank you.
Regards,
MOCUELSL

Re: Flowcode con PicKit 4

Posted: Fri Jun 01, 2018 1:00 pm
by Benj
Hello,

You can use the IPE software from Microchip (packaged with MPLABX) to manually program devices using the PICkit 4. Currently there are no working command line options so compile to chip from Flowcode doesn't currently work but is hopefully coming soon.

Re: Flowcode con PicKit 4

Posted: Mon Jun 04, 2018 7:18 am
by MOCUELSL
Good morning, Benj. I will compile with the IPE, thanks.

I also have a problem with a voltage meter in which I am currently working, since by updating the flowcode V8, it gives me compression errors that did not give me before. You could look at him to see where the problem is. Thank you.

Re: Flowcode con PicKit 4

Posted: Mon Jun 04, 2018 10:51 am
by Benj
Hello,

The problem is to do with the SPI hardware setup being different on the 24FJ1024GB610 device. I've now fixed the problem for you in the PIC16BIT SPI CAL file and will push the fix to the updates system later this morning.

For help using the updates system.
https://www.matrixtsl.com/wiki/index.ph ... ic_Updates