Simulation (RS232 component)

[PIC-Speed32]

RS232 simulation component
In the project, I have two (RS232 ports).
RS232 (0) is used.
RS232 (1) is not being used.
In the panel I have the (UART1 and UART2) replaced more often.
When I turn on the simulation, always RS232 (0) disappears.
No matter if selected (UART1 or UART2)
After the simulation, RS232 (0) will return.
The transmitted data can be seen in the window.

Sincerely
Uwe

[Benj]

Hello Uwe,

In the EXT properties for the RS232(0) there is a setting called show simulation. Please ensure that this is ticked and the RS232 window should then remain on the panel for simulation.

[PIC-Speed32]

Hello Benj.

exactly what it was.

Thank you very much

Uwe