Matrix user forums

Hi. I believe that Flowcode5 supports pic 10 and 12f? It says with hitech compiler only. Can't get it to generate hex or assy code either. Is there something I am missing with setting up hitech in parameters or something?

BoostC which is shipped with Flowcode, will work most of the 12F range. I believe it's the 10F range and only some of 12F range that requires Hitec C.
Full list of what is Hitec only can be found on page 13 of Flowcode V5 data sheet:
http://www.matrixmultimedia.com/resourc ... klet-2.pdf

Best way to find out is just compile flowchart to hex.
If it's Hitec only, then your get a compiler general error.

If you do want to use Flowcode with Hitec then settings are covered here:
http://www.matrixmultimedia.com/support ... f=68&t=788

Since your new to Flowcode, I recommend visiting Learning center here:
http://www.matrixmultimedia.com/lc_index.php
You can try the free online course and download examples to see how to create flowcharts.

When you have created your flowchart, If it does not work the way you have intended it to work see:
http://www.matrixmultimedia.com/mmforum ... =26&t=6936

Martin

Medelec 35, Thanks : ) This helps a lot as I was wondering why I couldn't compile. I still need to learn to get hitech c to work on some of my other chips but for now, I ordered some more compatible chips. Thanks again and have a great, safe new years.

Thanks Drakkor.
No problem just glad I could help you.

Martin