Good day Forum.
I'm trying out the new flowcode with my Pickit 3, but when i run the script I get the following error.
Launching the linker/assembler...
C:\Program Files\Flowcode\v5\Tools\PICkit3\PK3CMD.exe -P18F2550 -FPickit Test.hex -E -M -Y -V5
Return code = -1073741515
Flowcode was unable to transfer the flowchart to the microcontroller. Check the programmer options and physical connections.
The pickit works fine in mplabx.
And i did set the parameters to according to http://www.matrixmultimedia.com/support ... w=previous
Thank you
Pickit 3 Programming Error
Moderator: Benj
- DavidA
- Matrix Staff
- Posts: 1076
- Joined: Fri Apr 23, 2010 2:18 pm
- Location: Matrix Multimedia Ltd
- Has thanked: 58 times
- Been thanked: 258 times
- Contact:
Re: Pickit 3 Programming Error
Hi Koos,
I will have to check this on tuesday when i get back into the office, i wrote that FAQ quickly and forgot to check it was correct, shush dont tell my boss tho
I will have to check this on tuesday when i get back into the office, i wrote that FAQ quickly and forgot to check it was correct, shush dont tell my boss tho
Re: Pickit 3 Programming Error
Thanks David. I will send a letter of complaint to you boss.
No just kidding.
No just kidding.