use of eeprom memory area of PICs
Posted: Wed Feb 15, 2006 9:48 pm
Hi there,
I'm developing an application where it would be neccessary that if power is turned off and on again after that, the application returns to the state it was in before the mains shut off.
I use a 16F88 PIC, from the datasheet I learned that there's an EEPROM area available that could be used to store the application settings after a user action so I could retrieve the last operational settings from there upon a power up.
My question: How can I address such EEPROM and store/retrieve variables from within flowcode?
best regards, Fransky
I'm developing an application where it would be neccessary that if power is turned off and on again after that, the application returns to the state it was in before the mains shut off.
I use a 16F88 PIC, from the datasheet I learned that there's an EEPROM area available that could be used to store the application settings after a user action so I could retrieve the last operational settings from there upon a power up.
My question: How can I address such EEPROM and store/retrieve variables from within flowcode?
best regards, Fransky