How can I control a servo motor?
I am using the ECIO-40, and PWM, I have reduced the PWM frequency to a minimum, but nothing is happening!
I also tried turning on a pin for a few milli seconds, but it is only turning a few degrees and then stops.
What can I do?
For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 2 and 3.
2 posts • Page 1 of 1
- Matrix Staff
- Posts: 1060
- Joined: Fri Apr 23, 2010 2:18 pm
- Location: Matrix Multimedia Ltd
- Has thanked: 58 times
- Been thanked: 275 times