The EB006v9 D6 Power LED lights up even when J11 is set to PSU and no external power supply is connected (probably the Ghost chip is powered directly from the 5V USB).
I find this confusing... should it not instead stay off until PSU or USB power is actually applied as per J11 selection?
Operation of D6 Power LED on EB006v9 Programmer
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Operation of D6 Power LED on EB006v9 Programmer
Hello,
I have just tried this here on two EB006v9 boards and both have the Power LED off when the Voltage source jumper is in the PSU position and only a USB cable is inserted.
Do you have any additional circuitry connected to the E-block that could be re-routing power?
I have just tried this here on two EB006v9 boards and both have the Power LED off when the Voltage source jumper is in the PSU position and only a USB cable is inserted.
Do you have any additional circuitry connected to the E-block that could be re-routing power?
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel