Flowcode5 and 6 with CANbus
Posted: Sat Oct 03, 2015 12:00 pm
I have a project that includes CANbus, and if I compile it in Flowcode 5 it runs OK.
When i convert the project to FC6 and do a compilation the CANbus communication does not work.
When I compare settings in FC5 and FC6 the values are different, but not the values that I can change.
Is it some issue with the conversion of the project I have to take care of?
/Mike
When i convert the project to FC6 and do a compilation the CANbus communication does not work.
When I compare settings in FC5 and FC6 the values are different, but not the values that I can change.
Is it some issue with the conversion of the project I have to take care of?
/Mike