ultrasonic and servomotor
Moderator: Benj
ultrasonic and servomotor
Hello friends, I trying to do a flowchart with ultrasonic sensor and servomotor. But I don't know if is good my flowchart. I am working with arduino uno.
- Attachments
-
- ultra-servo_1.fcfx
- (8.27 KiB) Downloaded 265 times
-
- 20180604_224100.jpg (128.19 KiB) Viewed 3999 times
-
- 20180604_224054.jpg (137.9 KiB) Viewed 3999 times
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: ultrasonic and servomotor
Hi kalmar79,
No you have not set servo up correctly.
Servo_Controller channel is relating to how many servos you have in total.
E.g if you only have 1 servo then since channel starts at 0 you must use 0 for channel value.
If you are controlling 2 servos in total then use channel 0 for servo 1 and channel 1 for servo 2 etc.
Martin
No you have not set servo up correctly.
Servo_Controller channel is relating to how many servos you have in total.
E.g if you only have 1 servo then since channel starts at 0 you must use 0 for channel value.
If you are controlling 2 servos in total then use channel 0 for servo 1 and channel 1 for servo 2 etc.
Martin
Martin