Matrix user forums

Minor Bug:
I created a FC5 flowchart and added a mixture of a few random components.
After importing to FC6 the sizes are not in proportion to each other. for example compare size of RC5 to CAN:

Hi. These values will need tweaking in the upgrader.xml file (if you want to have a play its plugins/upgrader.xml). Its something we can tweak - this probably wont get in the next release but shouldn't take long.

Jonny

Hi Jonny thanks,
will have a play with the settings when I get a chance.
Going on a bit of a holiday from tomorrow over the next week so wont have as much time spare... unless bored in the evenings

I have just imported a FC5 file with 4 ADC components.
All of them imported with a funny aspect ratio (or X Y Z thing is not correct?): Hmm X Y Z thing
Im getting good with 3D terminology

Hi. I think X Y Z thing is the technical term.

They look pretty odd - I think there must be an issue with the scales in the converter somewhere, I can look into it. When you click on the ADC does it have a strange rotation or scale?

Jonny

I Jonny, I will PM the V5 flowchart as I would prefer that one not to be on the public forum,
Perhaps it will do the same for you after you import it?

I have just created new V5 Flowcharts with ADC and they import correctly.
So there must be a special condition for ADC to not import as it should.

JonnyW wrote:I think X Y Z thing is the technical term.

I may just get a new job in 3D since i'm learning all the technical terms.