I2C changing of the delay routine
Posted: Mon Feb 22, 2016 8:48 pm
Hello matrix team,
the software is written for a eeprom and you put a dummy delay of 10ms for all chips inside. Different Eeproms have differant write/read times. In my case,
I use a fram, who can be write and read up to 1 MHz-Bus timing. Transfering bigger datas takes a long time.
The feature request is to get a setup point to adjust the delay by user. Default stays at 10ms.
Best regards
Jörg
the software is written for a eeprom and you put a dummy delay of 10ms for all chips inside. Different Eeproms have differant write/read times. In my case,
I use a fram, who can be write and read up to 1 MHz-Bus timing. Transfering bigger datas takes a long time.
The feature request is to get a setup point to adjust the delay by user. Default stays at 10ms.
Best regards
Jörg