ARM USB trouble
Posted: Mon Apr 11, 2011 11:39 am
I was a happy FLOWCODE 4 for PIC user. However, recently, I made a crossgrade to Flowcode 4 for ARM (professional edition), and at the same time, bought an EB 185 ARM programmer and daughter board, as well as a C for ARM Microcontrollers and ARM ECIO.
Much to my amazement and after following all the recommended procedures my computer doesn't recognize the USB port of the ARM device.
I have Windows 7 (32 bit) installed, and pre-installed the drivers running the "ARMBoardDriverInstaller.exe" file as an administrator and emulating Windows XP. I also put the ARM programmer in program mode (power on, pressed and holded the PROG button switch, followed by a tap in the reset switch). As a last resource, I used an external USB hub, but the final result was the same.
A further attempt was addressed; this time, in another computer with Windows XP installed, but was also unsuccessful, the result being the same.
I'm beginning a little frustrated, and I don’t know what to do more. Any suggestions are welcome.
CC - Portugal
Much to my amazement and after following all the recommended procedures my computer doesn't recognize the USB port of the ARM device.
I have Windows 7 (32 bit) installed, and pre-installed the drivers running the "ARMBoardDriverInstaller.exe" file as an administrator and emulating Windows XP. I also put the ARM programmer in program mode (power on, pressed and holded the PROG button switch, followed by a tap in the reset switch). As a last resource, I used an external USB hub, but the final result was the same.
A further attempt was addressed; this time, in another computer with Windows XP installed, but was also unsuccessful, the result being the same.
I'm beginning a little frustrated, and I don’t know what to do more. Any suggestions are welcome.
CC - Portugal