Hello - I have looked around for forum hints on simulation problems and have not concluded. Here is my problem:
Simulator works if I step through a program. Running a program at speeds causes the components (Switches/Led's) not to graphically update. I do believe that the switches are recognized by FC7, but no updates. They will graphically update if I pause the program.
I updated to the lastest FC7 v7.3.0.5 From Dec 14th 2017. Using Windows Version 10.0.18362 Build 18362
Side note - The install for the new FC7 was great. It must have saved my reg number and name!
Any thoughts?
2D Simulation
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: 2D Simulation
Hello,
Without seeing your program it's hard to tell but do you have a delay in your main program loop? The delay allows Flowcode time to breathe and do things like updating the graphics on the panel window.
Without seeing your program it's hard to tell but do you have a delay in your main program loop? The delay allows Flowcode time to breathe and do things like updating the graphics on the panel window.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel