Hi Not sure if this is me or not
on 2d dash placed
generic lcd display then set to 4 x 16
switch array on port B
Analogue slider
The scale seams to be off or can you alter the zoom on each component ?
Under normal viewing the display shows lines 0,3 very small and lines 1,2 quite large and the test is quite burley.
Also in the lcd properties box there is a menu for lcd display R/W pin if hard wired to ground set to "false" if hard wired to ground the menu options shows"yes" , "no"
if I zoom so I can see the 4 lines on my display the analogue input slider is off the top of the screen
Screen res is set to 1680 x 1050
Steve
scale issue
Moderator: Benj
- Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
scale issue
- Attachments
-
- Capture2.JPG
- (72.09 KiB) Downloaded 319 times
-
- Capture1.JPG
- (92.96 KiB) Downloaded 319 times
-
- Capture.JPG
- (62.92 KiB) Downloaded 319 times
Success always occurs in private and failure in full view.
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: scale issue
Hi Steve,
I guess we will need to look at default sizes.
To alter size and position I personally use the position and size properties for the component ... Hope that helps
I guess we will need to look at default sizes.
To alter size and position I personally use the position and size properties for the component ... Hope that helps
- Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
Re: scale issue
cheers Leigh will have a go with that later
Steve
Steve
Success always occurs in private and failure in full view.