The display has connected 7 segments.
At emulation reports about a mistake
Compilation error?
Moderator: Benj
Compilation error?
- Attachments
-
- refuses to compile
- CAM.jpg (69.08 KiB) Viewed 2226 times
-
- warns
- SIM.jpg (54.73 KiB) Viewed 2226 times
-
- settings
- SET_LED.jpg (114.99 KiB) Viewed 2226 times
Re: Compilation error?
Osta wrote:The display has connected 7 segments.
At emulation reports about a mistake
- Attachments
-
- BG.fcfx
- project
- (9.99 KiB) Downloaded 149 times
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Compilation error?
As you have common pins 2 & 3 unconnected, flowchart will not compile.
You need to connect common pins 2 and 3.
If you only have x2 7seg displays instead of x4, then you need to use 7Segment(Single) instead of 7Segment(Quad).
If you can't find it then select search and enter 7seg
Martin
You need to connect common pins 2 and 3.
If you only have x2 7seg displays instead of x4, then you need to use 7Segment(Single) instead of 7Segment(Quad).
If you can't find it then select search and enter 7seg
Martin
Martin
Re: Compilation error?
Hi Martin!!!
Thanks for explanation.
I have so thought too... To make such decision
i was forced by an opportunity in
settings the mode - "aren't included".
I have made just as you have told and everything works!!!
Control "isn't included" to me it is unclear...
Osta
Thanks for explanation.
I have so thought too... To make such decision
i was forced by an opportunity in
settings the mode - "aren't included".
I have made just as you have told and everything works!!!
Control "isn't included" to me it is unclear...
Osta
- Attachments
-
- How does it work?
- SET_LED.jpg (98.69 KiB) Viewed 2205 times
-
- BG.fcfx
- Here is how I have made it
- (11.51 KiB) Downloaded 142 times