Serial Eeprom 24C32 not working

A forums to allow bugs and problems with Flowcode v7 to be reported and resolved.

Moderator: Benj

electronix
Posts: 58
Joined: Sat Aug 22, 2009 5:45 pm
Has thanked: 17 times
Been thanked: 7 times
Contact:

Serial Eeprom 24C32 not working

Postby electronix » Sat Jan 06, 2018 1:14 pm

Hi all.
So I`ve been trying to use the I2C Eeprom component without any success, has anybody else used it since upgrade 7.3?
It compilates ok, but when running the program it stops in the Read command.
The MCU speed seems ok after running the "blinker test" at several rates and also PWM channels runns at calculated speed.
Target is: 24EP512GU810@140Mhz

Annybody got a clue?

electronix.

User avatar
LeighM
Matrix Staff
Posts: 1865
Joined: Tue Jan 17, 2012 10:07 am
Has thanked: 436 times
Been thanked: 621 times
Contact:

Re: Serial Eeprom 24C32 not working

Postby LeighM » Mon Jan 29, 2018 5:01 pm

Hi,
Could you just check that the channel and port properties are correct in your project for the eeprom component?
There is a chance that the defaults have changed.
If it still fails, could you change to the "Software" channel and see if that works.
These users thanked the author LeighM for the post:
electronix (Tue Jan 30, 2018 9:59 am)
Rating: 5.26%
 

electronix
Posts: 58
Joined: Sat Aug 22, 2009 5:45 pm
Has thanked: 17 times
Been thanked: 7 times
Contact:

Re: Serial Eeprom 24C32 not working

Postby electronix » Tue Jan 30, 2018 9:59 am

Hi Leigh.

I just did the last upgrade of 7.3 and after some testing it seems to work in both HW and SW mode, so I guess its working, I will use it in a project later on though for proper testing.

Thanks a lot :-)
These users thanked the author electronix for the post:
Benj (Wed Jan 31, 2018 5:37 pm)
Rating: 5.26%